pgs not deep scrubbed in time
datacentre
2 Posts
September 23, 2024, 10:29 amQuote from datacentre on September 23, 2024, 10:29 am52 pgs not deep-scrubbed in time
error message is shown in warnings, how to resolve this issue
52 pgs not deep-scrubbed in time
error message is shown in warnings, how to resolve this issue
admin
2,930 Posts
September 23, 2024, 6:04 pmQuote from admin on September 23, 2024, 6:04 pmthis is a warning, you can try to increase the scrub speed from the Maintenance -> Scrub Speed ui page
do not increase the speed too fast if you have hdds or slow hardware, always check resource utilization charts for cpu/disk % util.
you can also change the speed in a custom way instead of the presets speed from the same ui page, moreover you can take full control of scrub parameters from the Configuration -> Ceph Configuration page.
this is a warning, you can try to increase the scrub speed from the Maintenance -> Scrub Speed ui page
do not increase the speed too fast if you have hdds or slow hardware, always check resource utilization charts for cpu/disk % util.
you can also change the speed in a custom way instead of the presets speed from the same ui page, moreover you can take full control of scrub parameters from the Configuration -> Ceph Configuration page.
pgs not deep scrubbed in time
datacentre
2 Posts
Quote from datacentre on September 23, 2024, 10:29 am52 pgs not deep-scrubbed in time
error message is shown in warnings, how to resolve this issue
52 pgs not deep-scrubbed in time
error message is shown in warnings, how to resolve this issue
admin
2,930 Posts
Quote from admin on September 23, 2024, 6:04 pmthis is a warning, you can try to increase the scrub speed from the Maintenance -> Scrub Speed ui page
do not increase the speed too fast if you have hdds or slow hardware, always check resource utilization charts for cpu/disk % util.
you can also change the speed in a custom way instead of the presets speed from the same ui page, moreover you can take full control of scrub parameters from the Configuration -> Ceph Configuration page.
this is a warning, you can try to increase the scrub speed from the Maintenance -> Scrub Speed ui page
do not increase the speed too fast if you have hdds or slow hardware, always check resource utilization charts for cpu/disk % util.
you can also change the speed in a custom way instead of the presets speed from the same ui page, moreover you can take full control of scrub parameters from the Configuration -> Ceph Configuration page.