OSD's on the first node not starting
valio
17 Posts
September 3, 2018, 7:17 amQuote from valio on September 3, 2018, 7:17 amHi, I have installed PetaSAN 2.1 and when try to add OSD on first node getting following error:
OSD status showing down. I have deleted OSD's and recreated again. Same result.
Hi, I have installed PetaSAN 2.1 and when try to add OSD on first node getting following error:
OSD status showing down. I have deleted OSD's and recreated again. Same result.
admin
2,930 Posts
September 3, 2018, 9:58 amQuote from admin on September 3, 2018, 9:58 amYou did deploy the first 3 nodes and all went well but now you can not add an osd via the Management Web ui..is this correct ?
Can you add osds to your other nodes ?
How much ram do you have ?
Do you see errors in /opt/petasan/log/ceph-disk.log ?
You did deploy the first 3 nodes and all went well but now you can not add an osd via the Management Web ui..is this correct ?
Can you add osds to your other nodes ?
How much ram do you have ?
Do you see errors in /opt/petasan/log/ceph-disk.log ?
valio
17 Posts
September 3, 2018, 10:14 amQuote from valio on September 3, 2018, 10:14 amHi,
You were right about memory per node. It was small test environment with 2 GB per node. I have increased it to 4 GB per node. Now all OSD's are starting
Hi,
You were right about memory per node. It was small test environment with 2 GB per node. I have increased it to 4 GB per node. Now all OSD's are starting
OSD's on the first node not starting
valio
17 Posts
Quote from valio on September 3, 2018, 7:17 amHi, I have installed PetaSAN 2.1 and when try to add OSD on first node getting following error:
OSD status showing down. I have deleted OSD's and recreated again. Same result.
Hi, I have installed PetaSAN 2.1 and when try to add OSD on first node getting following error:
OSD status showing down. I have deleted OSD's and recreated again. Same result.
admin
2,930 Posts
Quote from admin on September 3, 2018, 9:58 amYou did deploy the first 3 nodes and all went well but now you can not add an osd via the Management Web ui..is this correct ?
Can you add osds to your other nodes ?
How much ram do you have ?
Do you see errors in /opt/petasan/log/ceph-disk.log ?
You did deploy the first 3 nodes and all went well but now you can not add an osd via the Management Web ui..is this correct ?
Can you add osds to your other nodes ?
How much ram do you have ?
Do you see errors in /opt/petasan/log/ceph-disk.log ?
valio
17 Posts
Quote from valio on September 3, 2018, 10:14 amHi,
You were right about memory per node. It was small test environment with 2 GB per node. I have increased it to 4 GB per node. Now all OSD's are starting
Hi,
You were right about memory per node. It was small test environment with 2 GB per node. I have increased it to 4 GB per node. Now all OSD's are starting