brdarkmoon
2 Posts
Quote from brdarkmoon on December 29, 2018, 12:06 pm
Hello Guys,
I´ve got a problem with my deployment, well, i followed the quickstart guide to the letter, and the deployment went smoothly, nodes reported joining flawlessly, but after deploying 5 nodes, i am unable to access the management application at http://nodeip:5000
I am still able to access all nodes at ttp://nodeip:5001 but when i try port 5000 it is not reachable.
Would any of you have a clue about what could be happening?
Thank you in Advance
Hello Guys,
I´ve got a problem with my deployment, well, i followed the quickstart guide to the letter, and the deployment went smoothly, nodes reported joining flawlessly, but after deploying 5 nodes, i am unable to access the management application at http://nodeip:5000
I am still able to access all nodes at ttp://nodeip:5001 but when i try port 5000 it is not reachable.
Would any of you have a clue about what could be happening?
Thank you in Advance
admin
2,930 Posts
Quote from admin on December 30, 2018, 10:28 am
Were you able to access the management ui after node 3 completed building the cluster ? or you just deployed all 5 then tried ? If it is the earlier, maybe there could be an ip conflict. Else i would recommend you re-install + re-deploy the first 3 nodes, checking you ips/subnets, if you still have issues please show the output of
cat/opt/petasan/log/PetaSAN.log (of the 3rd node)
cat /etc/hosts
cat /opt/petasan/config/cluster_info.json
consul members
ceph status --cluster CLUSTER_NAME
Were you able to access the management ui after node 3 completed building the cluster ? or you just deployed all 5 then tried ? If it is the earlier, maybe there could be an ip conflict. Else i would recommend you re-install + re-deploy the first 3 nodes, checking you ips/subnets, if you still have issues please show the output of
cat/opt/petasan/log/PetaSAN.log (of the 3rd node)
cat /etc/hosts
cat /opt/petasan/config/cluster_info.json
consul members
ceph status --cluster CLUSTER_NAME
brdarkmoon
2 Posts
Quote from brdarkmoon on December 30, 2018, 11:52 am
Thank you for your answer admin.
I detected the problem.
I have created a base image of petasan, and when replicated it the hostname was the same for all..."rookie mistake...lol".
I´ve just redeployed it and all seems normal now
My toplogy is according to the image below:
Thank you again!
Thank you for your answer admin.
I detected the problem.
I have created a base image of petasan, and when replicated it the hostname was the same for all..."rookie mistake...lol".
I´ve just redeployed it and all seems normal now
My toplogy is according to the image below:
Thank you again!
