jfranco
1 Post
Quote from jfranco on June 23, 2017, 2:53 pm
Hello,
I´m testing 1.3 right now.
All installed and configured, but I cannot access the list disks page.
If I try to create a disk, the same thing happens, the page just keeps spinning.
I searched the logs and couldn´t find a solution.
Thanks,
Hello,
I´m testing 1.3 right now.
All installed and configured, but I cannot access the list disks page.
If I try to create a disk, the same thing happens, the page just keeps spinning.
I searched the logs and couldn´t find a solution.
Thanks,
admin
2,930 Posts
Quote from admin on June 23, 2017, 3:50 pm
The most likely cause is that the Ceph cluster has been built but there are less than 3 storage disks in the Ceph pool. Make sure you have at least 2 disks in your nodes since one disk is used by the system, you need at least another one to provide storage. If you identify this as your issue you can either add more disks then re-install PetaSAN (easiest in your case) or you can keep your built cluster and go to the Node List-> Physical Disk List page and add OSDs from the new disks you installed.
The most likely cause is that the Ceph cluster has been built but there are less than 3 storage disks in the Ceph pool. Make sure you have at least 2 disks in your nodes since one disk is used by the system, you need at least another one to provide storage. If you identify this as your issue you can either add more disks then re-install PetaSAN (easiest in your case) or you can keep your built cluster and go to the Node List-> Physical Disk List page and add OSDs from the new disks you installed.
